|
|
News and Press Releases
December 2007
TÜV approval for LaserGas II SP
The LaserGas II SP has recently achieved German TÜV approval for NH3+H2O. The requirements of guidelines EN 14181 and EN 14956 are implemented in the approval.
Our certified measurement ranges are
- 0 - 10 mg/m3 and 0 - 15 mg/m3 for NH3 and
- 0 - 30 %vol and 0 - 50 %vol for H2O.
To our knowledge the LaserGas II SP is the first laser-based analyser
that has been awarded TÜV approval for the very low NH3 measurement
ranges as commonly found in DeNOx (Ammonia slip) applications.
October 2007
LaserGas Dual Path (DP) analysers discontinued
As of 15 October 2007 the LaserGas I DP and LaserGas II DP analysers
have been discontinued. These analysers had been designed for
continuous emission monitoring applications, where regular validation
(zero and span check) of the analyser performance was required. With
the DP analysers this validation could be done on the stack.
For
these applications we now offer the LaserGas II SP. We have upgraded
this analyser to include automatic zero and span check functionality
as option.
Note that we of course continue to service and support
our installed base of DP analysers.
September 2007
Change of distribution in The Netherlands
NEO Monitors AS has recently appointed M&C Indumation as new
distributor for The Netherlands. The complete contact information for
M&C Indumation is found here.
September 2007
Change of distribution in Great Britain
NEO Monitors AS has recently appointed AMCS as distributor for Great Britain. The complete contact information
for AMCS is found here.
August 2007
Successful evaluation of the LaserGas II SP by EPRI
The LaserGas II SP has successfully participated in a lab test verification by the Electrical Power Research Institute (EPRI) in the USA. The objective of the test,
carried out at the University of California Riverside was to evaluate the LaserGas II SP over a range of Ammonia concentrations, temperatures, and moisture levels
commensurate with flue gas conditions at the economizer outlet of a coal fired boiler.
Amongst the four laser-based analysers tested the LaserGas II SP was "best in test"
when it comes to minimum detection limit and average precision.
A summary of the test report is available on request.
August 2007
NEW DISTRIBUTOR APPOINTED FOR TURKEY
NEO Monitors AS has recently appointed Tetra as distributor for Turkey. The complete contact information
for Tetra is found here. This appointment will considerably improve our presence and result in better
support of our customers in this region.
February 2007
LaserGas II SP Compact released
Based on the well-known LaserGas II SP this analyser is even more compact. It has specifically been designed for trace level measurement of atmospheric gases
(e.g. H2O, CO2, or O2), measurement across thin pipes (diameter down to 10 cm) and gas detection on measurement cells.
This analyser features a focused laser
beam so that it can measure through very thin nozzles (< 10 mm diameter). Thus, for applications with continuous purge to prevent dust from settling on the windows
the SP compact will require very small purge flow (< 150 l/hour per flange).
The LaserGas II SP Compact has already found wide acceptance in the German car industry
for fast in-situ ppm NH3 measurement across exhaust pipes of engine test stands.More product data and specifications may be
found here.
December 2006
New gases VCM and Formaldehyde
NEO Monitors AS has extended its range of gases to also cover Vinyl Monomer Chloride (VCM)
and Formaldehyde (CH2O). These gases are available for our complete LaserGas II product line
(Single Path, Open Path, and Multipass).
We can offer the following detection limits (specified for 1 m path, 25 degC, and 1 bar abs):
VCM 10 ppm
CH2O 1 ppm
Please contact us with your VCM or Formaldehyde applications.
November 2006
LaserGas I HCl awarded MCERTS
We are proud to announce that the LaserGas I HCl has been awarded MCERTS approval
with certified measurement ranges of 0 – 15 mg/m3 and 0 – 90 mg/m3. To our knowledge it
is the first laser-based HCl analyser to achieve MCERTS. The official listing may be found
on the Sira Env. homepage at http://www.sira.co.uk/MCERTS/MCERTSCertifiedProductsCEMS.pdf .
The LaserGas I HCl has carried TUV approval since 1999
(see http://www.umweltbundesamt.de/messeinrichtungen/moemi4.pdf), and has been successfully
installed in many CEM applications. More information about the LaserGas I is provided
at http://www.neomonitors.com/products/lasergas1.html
November 2006
CSA approval for LaserGas II product line
The LaserGas II product line has successfully passed CSA approval.
The approval covers LaserGas II Single Path, Multipass, and Open Path
analysers and includes indicators “C” and “US” for the Canadian and US market.
The analysers are available in general purpose and Class 1 Division 2 version.
The latter carries a non-incendive approval so no purge is required.
The analysers are even designed for Class 1 Division 1, which may be
obtained by adding a “Y” type purge.More information about the LaserGas II
product line may be found at http://www.neomonitors.com/products/
September 2006
Russian GOST approval for LaserGas II and LaserDust
NEO Monitors would like to inform their Russian customers that the entire LaserGas II and LaserDust
product lines carry the GOST-R approval. The LaserGas II line includes the Single Path, Open Path and
Multipass analysers (see http://www.neomonitors.com/products). All these analyzers are also approved for installation in hazardous zone "Rostexnadzor". The LaserDust series is available in
different configurations for different stack diameters namely the Medium Path, Long Path, and
Extra Long Path (see http://www.neomonitors.com/products/laserdust.html ).
Note also that our most selling LaserGas II Single Path analyser in addition has been awarded the
“Metrological Pattern Approval”.
March 2006
Open Path measurement up to 1000 m
NEO Monitors AS has extended performance of its LaserGas II Open Path (OP) analyser.
It is now available for path lengths up to 1000 m (one way). More information about the
LaserGas II OP may be found at http://www.neomonitors.com/products/lasergas2op.html.
February 2006
NEW MASTER DISTRIBUTOR APPOINTED FOR THE USA
NEO Monitors AS announces an important change in its USA
distribution. We are pleased to ally with Servomex as our new
distributor for the United States. Servomex has already extensive
knowledge of our LaserGas and LaserDust product lines from our
partnership in the Middle Eastern and South American markets. US
customers will be supported by Servomex Houston office. Contact
details are found here.
October 2005
NEW DISTRIBUTORS IN FRANCE
NEO Monitors AS is pleased to announce that it has recently appointed
Sistec and Ecomesure as new distributors for France. Note that Sistec
will represent our gas analysers (LaserGas), whereas Ecomesure will
take care of our Dust monitors (DM3, DM4, and LaserDust). Both
companies have long-time experience in the field of gas and dust
monitoring and will take over support of our French customers. The
complete contact information for both companies is found
here.
March 2005
CHANGE OF DISTRIBUTION IN CANADA
NEO Monitors AS is pleased to announce that it has strengthened its
representation in Canada. From 1st April 2005 our new exclusive
distributors are Vanko Analytics ltd for West Canada and Novatech for
East Canada. Both companies have long-time experience with gas
analysis and will provide excellent support and service to our
Canadian customers. The complete contact information for both
companies is found
here.
March 2005
MIDDLE EAST COUNTRIES NOW SUPPORTED FROM UAE OFFICE
NEO Monitors AS is cooperating with UK based Servomex ltd for
distribution of our products in the Middle East. We are pleased to
announce that Servomex has opened an office in the United Arab
Emirates that will support our product lines in the Middle East. The
list of countries covered by this agreement and the contact details of
the new office are found
here.
January 2005
NEW DISTRIBUTORS APPOINTED FOR POLAND AND SLOVAKIA
NEO Monitors AS has recently appointed Technopomiar as distributor for
Poland and Mertech as distributor for Slovakia. The complete contact
information for both companies is found
here. This
appointment will considerably improve our presence in Eastern Europe and
result in better support of our customers in this region.
September 1, 2004
NEW DISTRIBUTOR IN BELGIUM
The company M&C Products has been appointed to distributor for
NEO Monitors AS in Belgium from September 1, 2004.
M&C Products contact information can be found
here.
January 15, 2004
NEW GENERATION OF TDLAS GAS MONITORS FROM NORWAY
Formation of new NEO subsidiary dedicated to the supply of laser-based
gas monitors.
Read the complete press release here (Eibis)
Updated 2008-03-04
NEO Monitors is a subsidiary of Norsk Elektro Optikk A/S
|
|
|
